-Avoid plug restart in case of OverCurrent detection, introduced with central queue add
-publish uselaststate value
-if uselaststate is false we switch off the relay at restart
Manual control with a button press triggered the relay but 2 times (when pressing and releasing), fixing this.
Check that we have two consecutive readings of temperature above the threshold to trigger the actuator to OFF
And remove it by default to the shelly, as I see unjustified jumps of temperature above 80C.
The previous macro used SENS_SAR_MEAS_WAIT2_REG to identify if we have the reading capability was not working, so replacing it by a fresh one NO_INT_TEMP_READING, defined as a negation due to the fact that most of the ESP32 supports internal temperature reading.
* Add automatic stop of relay following ESP32 temperature
To avoid overheating when too much current goes through the device.
Add internal temperature reporting to SYStoMQTT
This function is not available with ESP32 S3 and C3
* Temp update and error log
Update of the temperature to get closer to the datasheet of the ESP32 -40 +85C
and add the module name to the error log
* Publishing/receiving inconsistencies
* General platformio.ini changes
General platformio.ini changes to allow for publishing/receiving settings to be defined in User_cofig.h instead of them only working if defined in the environments. Kept separate so far for discussion.
* Add ability to specify pulse length in ZactuatorONOFF
Add an additional parameter to the MQTT message to control the actuatorONOFF pulse length e.g. `mosquitto_pub -t home/OpenMQTTGateway_MEGA/commands/MQTTtoONOFF -m '{"gpio":15,"cmd":"high_pulse","pulse_length":25}'`
* Simplify initialization of pulselength
This will enable using button on the gateway to switch any controlled attached actuators/relays when pressed.
Adds the following macros:
- ACTUATOR_ON; 0 or 1, set to the output level of the gpio pin to turn the actuator on.
- ACTUATOR_ONOFF_DEFAULT; ACTUATOR_ON or !ACTUATOR_ON, set to the state desired on reset.
- ACTUATOR_BUTTON_TRIGGER_LEVEL; 0 or 1, set to the sensing level which to detect a button press to change the actuator state.
Rename set commands to config
correct json buffer size and gateway name
replace state to cmd
replace set by config
add restart and erase command
add unicity to gateway command switches
BLE devices shouldn't be child of the gateway
make the BTtoMQTT topic consistent with other definitions
Florian