Erasing the nvs before the start of WM prevent WM from starting, revert a part of #2075
Also remove the erase from setupWiFiManager method
Co-authored-by: Florian <1technophile@users.noreply.github.com>
And enable to launch the loop when offline: false and serial communication layer is activated
Co-authored-by: Florian <1technophile@users.noreply.github.com>
Refactor LED handling into a library
Use a task instead of relying on the loop for precise timing
Co-authored-by: Florian <1technophile@users.noreply.github.com>
* First build with IDF, tested with esp32dev-ble only.
* Fix frameworks for non-esp32 boards
* Add blufi support.
* Adds an environment to use esp-idf and Arduino as a component to facilitate incorporating blufi for onboarding and configuration.
---------
Co-authored-by: h2zero <powellperalata@gmail.com>
Manual control with a button press triggered the relay but 2 times (when pressing and releasing), fixing this.
Check that we have two consecutive readings of temperature above the threshold to trigger the actuator to OFF
And remove it by default to the shelly, as I see unjustified jumps of temperature above 80C.
This will provide the expected funtionality for the reset trigger when the button is pressed for more than 10 seconds.
Also allows the same pin to be used as an actuator/relay trigger if pressed for less than 10 seconds.
This will enable using button on the gateway to switch any controlled attached actuators/relays when pressed.
Adds the following macros:
- ACTUATOR_ON; 0 or 1, set to the output level of the gpio pin to turn the actuator on.
- ACTUATOR_ONOFF_DEFAULT; ACTUATOR_ON or !ACTUATOR_ON, set to the state desired on reset.
- ACTUATOR_BUTTON_TRIGGER_LEVEL; 0 or 1, set to the sensing level which to detect a button press to change the actuator state.
