f5b33104ef
Getting started: - New 15-minute Getting Started guide featuring the two most popular tracks (BLE on esp32dev-ble, RF on lilygo-rtl_433), with broker setup and a verification step - Sidebar restructured around the new-user journey; upload options numbered by ease; Gitpod upload method removed Home page: - VitePress hero with clear actions, larger hero image - How-it-works pipeline diagram shared as a component (responsive via container queries), use-case grid, bigger video tiles without the image lightbox, refreshed press coverage list, functions pills - Support section pointing to Theengs Bridge and github.com/sponsors/1technophile Upload flow: - Decision-oriented upload landing page (journey strip, method cards, comparison table) - Pre-flight checklist and driver troubleshooting on the web installer - Guided environment picker (bridge + hardware wizard) replacing the filter chips, with manifest-verified recommendations - Post-flash next-steps card linking to the portal and verification Board images: - custom_img key in environments.ini and board photos for all web-flashable environments (licenses recorded); private prod_env.ini environments excluded from boards-info.json Corrections: - RF frequency coverage stated as 433/315/868/915MHz - Removed references to the retired compatible.openmqttgateway.com site (BLE list is decoder.theengs.io), the discontinued Theengs Plug, and the private sponsor forum Claude-Session: https://claude.ai/code/session_01TYysQW8tpmt1dWWuzKhTLi Co-authored-by: Florian <1technophile@users.noreply.github.com> Co-authored-by: Claude Fable 5 <noreply@anthropic.com>
29 lines
969 B
Markdown
29 lines
969 B
Markdown
# IR gateway
|
|
## Compatible parts
|
|
|Module|Purpose|
|
|
|-|-|
|
|
|IR diode|Emitting|
|
|
|IR receiver|Receiving|
|
|
|transistor 2N2222|Amplify uC signal for the IR diode|
|
|
|330 ohms resistor|-|
|
|
|220 ohms resistor|limit current to LED|
|
|
|
|
The IR setup can work with bc547 and a 4x3 LED-Matrix.
|
|
|
|
## Pinout
|
|
|Board| Receiver Pin| Emitter Pin|
|
|
|-|:-:|:-:|
|
|
|ESP8266|D4|D0|
|
|
|ESP32|27/**26**|14|
|
|
|
|
Connect the Emitter and Receiver to a 5V supply source, and the ground of your supply source to the ground of your board.
|
|
|
|
## ESP8266 Hardware setup
|
|
|
|
|
|
## ESP32 Hardware setup
|
|
|
|
|
|
## Credits
|
|
This gateway exists thanks to the work done on [IRRemote](https://github.com/z3t0/Arduino-IRremote) and [IRremoteESP8266](https://github.com/crankyoldgit/IRremoteESP8266) libraries. Thanks for the works of contributors and especially [@crankyoldgit](https://github.com/crankyoldgit) for its active contributions.
|