f5b33104ef
Getting started: - New 15-minute Getting Started guide featuring the two most popular tracks (BLE on esp32dev-ble, RF on lilygo-rtl_433), with broker setup and a verification step - Sidebar restructured around the new-user journey; upload options numbered by ease; Gitpod upload method removed Home page: - VitePress hero with clear actions, larger hero image - How-it-works pipeline diagram shared as a component (responsive via container queries), use-case grid, bigger video tiles without the image lightbox, refreshed press coverage list, functions pills - Support section pointing to Theengs Bridge and github.com/sponsors/1technophile Upload flow: - Decision-oriented upload landing page (journey strip, method cards, comparison table) - Pre-flight checklist and driver troubleshooting on the web installer - Guided environment picker (bridge + hardware wizard) replacing the filter chips, with manifest-verified recommendations - Post-flash next-steps card linking to the portal and verification Board images: - custom_img key in environments.ini and board photos for all web-flashable environments (licenses recorded); private prod_env.ini environments excluded from boards-info.json Corrections: - RF frequency coverage stated as 433/315/868/915MHz - Removed references to the retired compatible.openmqttgateway.com site (BLE list is decoder.theengs.io), the discontinued Theengs Plug, and the private sponsor forum Claude-Session: https://claude.ai/code/session_01TYysQW8tpmt1dWWuzKhTLi Co-authored-by: Florian <1technophile@users.noreply.github.com> Co-authored-by: Claude Fable 5 <noreply@anthropic.com>
25 lines
739 B
Markdown
25 lines
739 B
Markdown
# GSM 2G gateway
|
|
## Compatible parts
|
|
|
|
|Module|Purpose|
|
|
|-|-|
|
|
|A6|GSM GPRS module|
|
|
|A7|GSM GPRS module with GPS|
|
|
|
|
## Hardware setup
|
|
|
|
|Module Pin|NodeMCU / ESP8266 Pin|
|
|
|-|:-:|
|
|
|H_RXD|D6|
|
|
|H_TXD|D7|
|
|
|GND|GND|
|
|
|VCC5|MOSFET driven by D5|
|
|
|
|
For VCC5 you can power it directly all the time with an USB cable or use a MOSFET like [here](https://gitlab.com/stavros/A6-ESP8266-breakout/raw/master/images/schematic.png)
|
|
|
|
Don't use the nodemcu/wemos 5V pin for the A6/7 power, use a dedicated power supply for both or dedicated to the A6/7 with at least 2 amps ability.
|
|
|
|
So as to start your A6/7 module press the red button for 4 seconds, or link the PWR_KEY GPIO to VCC5.0 for the same time.
|
|
|
|
|