Florian
441ab1c0b7
* some minor correction after coadcy checks * Put serial communication speed as a parameter in user_config.h * complete gateway file receiving ok sending ko #32 * add rfm69 to CI * change receiver key and minor improvments #32 now ok on receiving and sending with RFM69 * add schema and tested pinout for RFM69/RF/IR wiring #32 * RFM69 library add * Implement newremoteswitchlibrary for KlikAanKlikUit / ClickOnClickOff protocol #3 * add dependency for CI and link to the library * compilation error for arduino correction * Sketch size decrease * remove nano from CI * Divide user_config into one file per gateway/sensor for lisibility
40 lines
1.4 KiB
C
40 lines
1.4 KiB
C
/*
|
|
OpenMQTTGateway - ESP8266 or Arduino program for home automation
|
|
|
|
Act as a wifi or ethernet gateway between your 433mhz/infrared IR signal and a MQTT broker
|
|
Send and receiving command by MQTT
|
|
|
|
This files enables to set your parameter for the DHT11/22 sensor
|
|
|
|
Copyright: (c)Florian ROBERT
|
|
|
|
This file is part of OpenMQTTGateway.
|
|
|
|
OpenMQTTGateway is free software: you can redistribute it and/or modify
|
|
it under the terms of the GNU General Public License as published by
|
|
the Free Software Foundation, either version 3 of the License, or
|
|
(at your option) any later version.
|
|
|
|
OpenMQTTGateway is distributed in the hope that it will be useful,
|
|
but WITHOUT ANY WARRANTY; without even the implied warranty of
|
|
MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. See the
|
|
GNU General Public License for more details.
|
|
|
|
You should have received a copy of the GNU General Public License
|
|
along with this program. If not, see <http://www.gnu.org/licenses/>.
|
|
*/
|
|
|
|
/*-------------------PIN DEFINITIONS----------------------*/
|
|
#ifdef I2C_Wiring // With Support for I2C Modules
|
|
#define DHT_RECEIVER_PIN 14 //on nodeMCU this is D5 GPIO14
|
|
#endif
|
|
|
|
#ifdef Classic_Wiring // Without Support for I2C Modules
|
|
#define DHT_RECEIVER_PIN 0 //on nodeMCU this is D3 GPIO0
|
|
#endif
|
|
|
|
#ifdef RFM69_Wiring // Without Support for I2C Modules and HM10 or 11
|
|
#define DHT_RECEIVER_PIN 0 //on nodeMCU this is D3 GPIO0
|
|
#endif
|
|
|