Florian
441ab1c0b7
* some minor correction after coadcy checks * Put serial communication speed as a parameter in user_config.h * complete gateway file receiving ok sending ko #32 * add rfm69 to CI * change receiver key and minor improvments #32 now ok on receiving and sending with RFM69 * add schema and tested pinout for RFM69/RF/IR wiring #32 * RFM69 library add * Implement newremoteswitchlibrary for KlikAanKlikUit / ClickOnClickOff protocol #3 * add dependency for CI and link to the library * compilation error for arduino correction * Sketch size decrease * remove nano from CI * Divide user_config into one file per gateway/sensor for lisibility
39 lines
1.5 KiB
C
39 lines
1.5 KiB
C
/*
|
|
OpenMQTTGateway - ESP8266 or Arduino program for home automation
|
|
|
|
Act as a wifi or ethernet gateway between your 433mhz/infrared IR signal and a MQTT broker
|
|
Send and receiving command by MQTT
|
|
|
|
This files enables to set your parameter for the bluetooth low energy gateway (beacons detection)
|
|
|
|
Copyright: (c)Florian ROBERT
|
|
|
|
This file is part of OpenMQTTGateway.
|
|
|
|
OpenMQTTGateway is free software: you can redistribute it and/or modify
|
|
it under the terms of the GNU General Public License as published by
|
|
the Free Software Foundation, either version 3 of the License, or
|
|
(at your option) any later version.
|
|
|
|
OpenMQTTGateway is distributed in the hope that it will be useful,
|
|
but WITHOUT ANY WARRANTY; without even the implied warranty of
|
|
MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. See the
|
|
GNU General Public License for more details.
|
|
|
|
You should have received a copy of the GNU General Public License
|
|
along with this program. If not, see <http://www.gnu.org/licenses/>.
|
|
*/
|
|
/*----------------------BT topics & parameters-------------------------*/
|
|
#define subjectBTtoMQTT "home/BTtoMQTT/"
|
|
#define HM-10
|
|
//#define HM-11 // uncomment this line if you use HM-11 and comment the line above
|
|
|
|
/*-------------------PIN DEFINITIONS----------------------*/
|
|
#ifdef ESP8266
|
|
#define BT_RX 13 //D7 ESP8266 RX connect HM-10 or 11 TX
|
|
#define BT_TX 12 //D6 ESP8266 TX connect HM-10 or 11 RX
|
|
#else
|
|
#define BT_RX 5 //arduino RX connect HM-10 or 11 TX
|
|
#define BT_TX 6 //arduino TX connect HM-10 or 11 RX
|
|
#endif
|