Update IRRemoteESP8266 version to 2.5.5

factorize IR send signal function between the 2 types of receiving
Add new IRRemoteESP8266 protocols
replace pins on mega according schema
remove unecessaries spaces

lib/IRremoteESP8266/examples/JVCPanasonicSendDemo/JVCPanasonicSendDemo.ino

@@ -5,7 +5,7 @@
  * JVC and Panasonic protocol added by Kristian Lauszus (Thanks to zenwheel and other people at the original blog post)
  *
  * An IR LED circuit *MUST* be connected to the ESP8266 on a pin
- * as specified by IR_LED below.
+ * as specified by kIrLed below.
  *
  * TL;DR: The IR LED needs to be driven by a transistor for a good result.
  *
@@ -34,14 +34,13 @@
 #include <IRremoteESP8266.h>
 #include <IRsend.h>
 
-#define PanasonicAddress      0x4004     // Panasonic address (Pre data)
-#define PanasonicPower        0x100BCBD  // Panasonic Power button
+const uint16_t kPanasonicAddress = 0x4004;   // Panasonic address (Pre data)
+const uint32_t kPanasonicPower = 0x100BCBD;  // Panasonic Power button
+const uint16_t kJVCPower = 0xC5E8;
 
-#define JVCPower              0xC5E8
+const uint16_t kIrLed = 4;  // ESP8266 GPIO pin to use. Recommended: 4 (D2).
 
-#define IR_LED 4  // ESP8266 GPIO pin to use. Recommended: 4 (D2).
-
-IRsend irsend(IR_LED);  // Set the GPIO to be used to sending the message.
+IRsend irsend(kIrLed);  // Set the GPIO to be used to sending the message.
 
 void setup() {
   irsend.begin();
@@ -50,18 +49,15 @@ void setup() {
 void loop() {
   // This should turn your TV on and off
 #if SEND_PANASONIC
-  irsend.sendPanasonic(PanasonicAddress, PanasonicPower);
+  irsend.sendPanasonic(kPanasonicAddress, kPanasonicPower);
 #else  // SEND_PANASONIC
   Serial.println("Can't send because SEND_PANASONIC has been disabled.");
 #endif  // SEND_PANASONIC
 
 #if SEND_JVC
-  irsend.sendJVC(JVCPower, 16, 0);  // hex value, 16 bits, no repeat
-  // see http://www.sbprojects.com/knowledge/ir/jvc.php for information
-  delayMicroseconds(50);
-  irsend.sendJVC(JVCPower, 16, 1);  // hex value, 16 bits, repeat
-  delayMicroseconds(50);
+  irsend.sendJVC(kJVCPower, 16, 1);  // hex value, 16 bits, single repeat
 #else  // SEND_JVC
   Serial.println("Can't send because SEND_JVC has been disabled.");
 #endif  // SEND_JVC
+  delay(10000);  // Wait 10 seconds before we repeat everything.
 }