adaptative MQTT MAX PACKET SIZE

change mqtt max packet size depending on the board and display the value on serial monitor

OpenMQTTGateway.ino

@@ -111,6 +111,7 @@
 #endif
 // array to store previous received RFs, IRs codes and their timestamps
 #if defined(ESP8266) || defined(ESP32)
+#define MQTT_MAX_PACKET_SIZE 1024
 #define array_size 12
 unsigned long ReceivedSignal[array_size][2] ={{0,0},{0,0},{0,0},{0,0},{0,0},{0,0},{0,0},{0,0},{0,0},{0,0},{0,0},{0,0}};
 #else
@@ -239,11 +240,12 @@ void callback(char* topic, byte* payload, unsigned int length) {
 
 void setup()
 {
+  //Launch serial for debugging purposes
+  Serial.begin(SERIAL_BAUD);
+  
   #if defined(ESP8266) || defined(ESP32)
-    //Launch serial for debugging purposes
+    #ifdef ESP8266
-    #if defined(ZgatewaySRFB) || defined(ESP32)
+      Serial.end();
-      Serial.begin(SERIAL_BAUD); // in the case of sonoff RF Bridge the link to the RF emitter/receiver is made by serial and need TX/RX
-    #else
       Serial.begin(SERIAL_BAUD, SERIAL_8N1, SERIAL_TX_ONLY);
     #endif
     #if defined(ESP8266) && !defined(ESPWifiManualSetup)
@@ -375,6 +377,10 @@ void setup()
   #ifdef ZsensorGPIOInput
     setupGPIOInput();
   #endif
+  
+  trc(F("MQTT_MAX_PACKET_SIZE"));
+  trc(MQTT_MAX_PACKET_SIZE);
+  trc(F("Setup OpenMQTTGateway end"));
 }
 
 

config_IR.h

@@ -39,7 +39,7 @@
 #define repeatIRwMQTT false // do we repeat a received signal by using mqtt
 #define RawDirectForward false // direct repeat of IR signal with raw data
 #define RawFrequency 38 // raw frequency sending
-//#define DumpMode true // uncomment so as to see big dumps of IR codes, put also #define MQTT_MAX_PACKET_SIZE 1024 into the library pubsubclient.h by instead of #define MQTT_MAX_PACKET_SIZE 128  
+//#define DumpMode true // uncomment so as to see big dumps of IR codes
 
 #define pubIRunknownPrtcl false // key to avoid mqtt publication of unknown IR protocol (set to true if you want to publish unknown protocol)
 #define PanasonicAddress      0x4004     // Panasonic address (Pre data)