Npm docs setup (#834)

* added vuepress to package json
* use vuepress from package json

docs/use/actuators.md

@@ -8,7 +8,7 @@ So as to pilot the GPIO use the following commands with [simple receiving](../up
 OFF command:
 `mosquitto_pub -t home/OpenMQTTGateway_MEGA/commands/MQTTtoONOFF/setOFF -m 15`
 
-ON command
+ON command:
 `mosquitto_pub -t home/OpenMQTTGateway_MEGA/commands/MQTTtoONOFF/setON -m 15`
 
 or with [json receiving](../upload/pio.md#api)
@@ -16,7 +16,7 @@ or with [json receiving](../upload/pio.md#api)
 OFF command:
 `mosquitto_pub -t home/OpenMQTTGateway_MEGA/commands/MQTTtoONOFF -m '{"gpio":15,"cmd":0}'`
 
-ON command
+ON command:
 `mosquitto_pub -t home/OpenMQTTGateway_MEGA/commands/MQTTtoONOFF -m '{"gpio":15,"cmd":1}'`
 
 ## FASTLED
@@ -28,7 +28,7 @@ ON command
 2. Start fire animation (Fire2012)
 
 ### Hardware wiring
-Theoreticaly it should be possible to use every free IO pin. But after some tests only pin D2 works at WEMOS D1. Other platforms can work.
+Theoretically it should be possible to use every free IO pin. But after some tests only pin D2 works at WEMOS D1. Other platforms can work.
 The default setting use NEOPIXEL (WS2812B). The simplest wiring is direct connect D2 to data pin of LED stripe and connect VCC/GND to power source. You should also add an capacitor.
 
 ## PWM

docs/use/ble.md

@@ -86,14 +86,14 @@ you can also force a scan to be done by the following command:
 `mosquitto_pub -t home/OpenMQTTGateway/commands/MQTTtoBT/config -m '{"interval":0}'`
 
 ::: tip
-With Home Assistant, this command is directly avalaible through MQTT auto discovery as a switch into the HASS OpenMQTTGateway device entities list.
+With Home Assistant, this command is directly available through MQTT auto discovery as a switch into the HASS OpenMQTTGateway device entities list.
 :::
 
 Once the forced scan has completed, the previous scan interval value will be restored. Forcing a scan command trigger also a BLE connect process after the scan (see below).
 
 The default value `TimeBtwRead` is set into config_BT.h or into your .ini file for platformio users.
 
-::: info
+::: tip INFO
 For certain devices like LYWSD03MMC OpenMQTTGateway use a connection (due to the fact that the advertized data are encrypted), this connection mechanism is launched after every `ScanBeforeConnect` per default, you can modify it by following the procedure below.
 :::