Apply VSC auto format to the code and indent macros for readability

main/ZsensorGPIOInput.ino

@@ -31,15 +31,16 @@
 #ifdef ZsensorGPIOInput
 
 unsigned long lastDebounceTime = 0;
-int InputState = 3;             // Set to 3 so that it reads on startup
-int lastInputState = 3; 
+int InputState = 3; // Set to 3 so that it reads on startup
+int lastInputState = 3;
 
-
-void setupGPIOInput() {
-  pinMode(GPIOInput_PIN, INPUT_PULLUP);     // declare GPIOInput pin as input_pullup to prevent floating. Pin will be high when not connected to ground
+void setupGPIOInput()
+{
+  pinMode(GPIOInput_PIN, INPUT_PULLUP); // declare GPIOInput pin as input_pullup to prevent floating. Pin will be high when not connected to ground
 }
 
-void MeasureGPIOInput(){
+void MeasureGPIOInput()
+{
   int reading = digitalRead(GPIOInput_PIN);
 
   // check to see if you just pressed the button
@@ -47,41 +48,45 @@ void MeasureGPIOInput(){
   // since the last press to ignore any noise:
 
   // If the switch changed, due to noise or pressing:
-  if (reading != lastInputState) {
+  if (reading != lastInputState)
+  {
     // reset the debouncing timer
     lastDebounceTime = millis();
-    
   }
 
-  if ((millis() - lastDebounceTime) > GPIOInputDebounceDelay) {
+  if ((millis() - lastDebounceTime) > GPIOInputDebounceDelay)
+  {
     // whatever the reading is at, it's been there for longer than the debounce
     // delay, so take it as the actual current state:
-  #if defined(ESP8266) || defined(ESP32) 
+#if defined(ESP8266) || defined(ESP32)
     yield();
-  #endif
+#endif
     // if the Input state has changed:
-    if (reading != InputState) {
+    if (reading != InputState)
+    {
       InputState = reading;
       trc(F("Creating GPIOInput buffer"));
       const int JSON_MSG_CALC_BUFFER = JSON_OBJECT_SIZE(1);
       StaticJsonBuffer<JSON_MSG_CALC_BUFFER> jsonBuffer;
-      JsonObject& GPIOdata = jsonBuffer.createObject();
-      if (InputState == HIGH) {
+      JsonObject &GPIOdata = jsonBuffer.createObject();
+      if (InputState == HIGH)
+      {
         trc(F("GPIO HIGH"));
-        pub(subjectGPIOInputtoMQTT,"HIGH");
+        pub(subjectGPIOInputtoMQTT, "HIGH");
         GPIOdata.set("gpio", "HIGH");
       }
-      if (InputState == LOW) {
+      if (InputState == LOW)
+      {
         trc(F("GPIO LOW"));
-        GPIOdata.set("gpio","LOW");
-        pub(subjectGPIOInputtoMQTT,"LOW");
+        GPIOdata.set("gpio", "LOW");
+        pub(subjectGPIOInputtoMQTT, "LOW");
       }
-      if(GPIOdata.size()>0) pub(subjectGPIOInputtoMQTT,GPIOdata);
+      if (GPIOdata.size() > 0)
+        pub(subjectGPIOInputtoMQTT, GPIOdata);
     }
   }
 
   // save the reading. Next time through the loop, it'll be the lastInputState:
   lastInputState = reading;
- 
 }
 #endif