User config division (#97)

* some minor correction after coadcy checks

* Put serial communication speed as a parameter in user_config.h

* complete gateway file

receiving ok
sending ko
#32

* add rfm69 to CI

* change receiver key and minor improvments

#32

now ok on receiving and sending with RFM69

* add schema and tested pinout for RFM69/RF/IR wiring

#32

* RFM69 library add

* Implement newremoteswitchlibrary for KlikAanKlikUit / ClickOnClickOff protocol

#3

* add dependency for CI and link to the library

* compilation error for arduino correction

* Sketch size decrease

* remove nano from CI

* Divide user_config into one file per gateway/sensor for lisibility

config_BT.h

@@ -0,0 +1,38 @@
+/*  
+  OpenMQTTGateway  - ESP8266 or Arduino program for home automation 
+
+   Act as a wifi or ethernet gateway between your 433mhz/infrared IR signal  and a MQTT broker 
+   Send and receiving command by MQTT
+ 
+   This files enables to set your parameter for the bluetooth low energy gateway (beacons detection)
+  
+    Copyright: (c)Florian ROBERT
+  
+    This file is part of OpenMQTTGateway.
+    
+    OpenMQTTGateway is free software: you can redistribute it and/or modify
+    it under the terms of the GNU General Public License as published by
+    the Free Software Foundation, either version 3 of the License, or
+    (at your option) any later version.
+
+    OpenMQTTGateway is distributed in the hope that it will be useful,
+    but WITHOUT ANY WARRANTY; without even the implied warranty of
+    MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE.  See the
+    GNU General Public License for more details.
+
+    You should have received a copy of the GNU General Public License
+    along with this program.  If not, see <http://www.gnu.org/licenses/>.
+*/
+/*----------------------BT topics & parameters-------------------------*/
+#define subjectBTtoMQTT "home/BTtoMQTT/"
+#define HM-10 
+//#define HM-11 // uncomment this line if you use HM-11 and comment the line above
+
+/*-------------------PIN DEFINITIONS----------------------*/
+#ifdef ESP8266
+  #define BT_RX 13 //D7 ESP8266 RX connect HM-10 or 11 TX
+  #define BT_TX 12 //D6 ESP8266 TX connect HM-10 or 11 RX
+#else
+  #define BT_RX 5 //arduino RX connect HM-10 or 11 TX
+  #define BT_TX 6 //arduino TX connect HM-10 or 11 RX
+#endif