User config division (#97)

* some minor correction after coadcy checks * Put serial communication speed as a parameter in user_config.h * complete gateway file receiving ok sending ko #32 * add rfm69 to CI * change receiver key and minor improvments #32 now ok on receiving and sending with RFM69 * add schema and tested pinout for RFM69/RF/IR wiring #32 * RFM69 library add * Implement newremoteswitchlibrary for KlikAanKlikUit / ClickOnClickOff protocol #3 * add dependency for CI and link to the library * compilation error for arduino correction * Sketch size decrease * remove nano from CI * Divide user_config into one file per gateway/sensor for lisibility
2017-09-01 00:41:29 +02:00
1 parent f8ede4aa94
commit 441ab1c0b7
@@ -0,0 +1,50 @@
+/*  
+  OpenMQTTGateway  - ESP8266 or Arduino program for home automation 
+
+   Act as a wifi or ethernet gateway between your 433mhz/infrared IR signal  and a MQTT broker 
+   Send and receiving command by MQTT
+ 
+   This files enables to set your parameter for the BH1750 sensor
+
+    Copyright: (c) Hans-Juergen Dinges  
+    
+    This file is part of OpenMQTTGateway.
+    
+    OpenMQTTGateway is free software: you can redistribute it and/or modify
+    it under the terms of the GNU General Public License as published by
+    the Free Software Foundation, either version 3 of the License, or
+    (at your option) any later version.
+
+    OpenMQTTGateway is distributed in the hope that it will be useful,
+    but WITHOUT ANY WARRANTY; without even the implied warranty of
+    MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE.  See the
+    GNU General Public License for more details.
+
+    You should have received a copy of the GNU General Public License
+    along with this program.  If not, see <http://www.gnu.org/licenses/>.
+
+   Connection Schemata:
+   --------------------
+
+   BH1750 ------> Arduino Uno ----------> ESP8266
+   ==============================================
+   Vcc ---------> 5V -------------------> Vu (5V)
+   GND ---------> GND ------------------> GND
+   SCL ---------> Pin A5 ---------------> D1
+   SDA ---------> Pin A4 ---------------> D2
+   ADD ---------> N/C (Not Connected) --> N/C (Not Connected)
+
+*/
+
+#define bh1750_always true // if false when the current value for light Level (Lux) is the same as previous one don't send it by MQTT
+#define TimeBetweenReadingBH1750 30000
+
+/*----------------------------USER PARAMETERS-----------------------------*/
+/*-------------DEFINE YOUR MQTT PARAMETERS BELOW----------------*/
+#define LUX   "home/LIGHTtoMQTT/lux"
+#define FTCD  "home/LIGHTtoMQTT/ftcd"
+#define WATTSM2  "home/LIGHTtoMQTT/wattsm2"
+
+//Time used to wait for an interval before resending measured values
+unsigned long timebh1750 = 0;
+int BH1750_i2c_addr = 0x23; // Light Sensor I2C Address