moves some parameters to config files

ZgatewayBT.ino

@@ -34,7 +34,6 @@ Thanks to wolass https://github.com/wolass for suggesting me HM 10 and dinosd ht
 #define RESPONSE_MSG "OK+DISIS"
 #define RESP_END_MSG "OK+DISCE"
 #define SETUP_MSG "OK+RESET"
-#define TimeBtw_Read 10000
 
 SoftwareSerial softserial(BT_RX, BT_TX);
 

ZsensorDHT.ino

@@ -30,20 +30,14 @@
 #ifdef ZsensorDHT
 #include <DHT.h>
 #include <DHT_U.h>
-#define dht_always true // if false when the current value for temp or hum is the same as previous one don't send it by MQTT
-#define TimeBetweenReading 30000
-DHT dht(DHT_RECEIVER_PIN,DHT22); // Defined in User_config.h
 
-/*----------------------------USER PARAMETERS-----------------------------*/
+DHT dht(DHT_RECEIVER_PIN,DHT22); 
-/*-------------DEFINE YOUR MQTT PARAMETERS BELOW----------------*/
-#define HUM1   "home/DHTtoMQTT/dht1/hum"
-#define TEMP1  "home/DHTtoMQTT/dht1/temp"
 
 //Time used to wait for an interval before resending temp and hum
 unsigned long timedht = 0;
 
 void MeasureTempAndHum(){
-  if (millis() > (timedht + TimeBetweenReading)) {//retriving value of temperature and humidity of the box from DHT every xUL
+  if (millis() > (timedht + TimeBetweenReadingDHT)) {//retriving value of temperature and humidity of the box from DHT every xUL
     timedht = millis();
     static float persistedh;
     static float persistedt;

config_BT.h

@@ -25,6 +25,7 @@
 */
 /*----------------------BT topics & parameters-------------------------*/
 #define subjectBTtoMQTT "home/BTtoMQTT/"
+#define TimeBtw_Read 10000 //define the time between 2 scans
 #define HM-10 
 //#define HM-11 // uncomment this line if you use HM-11 and comment the line above
 

config_DHT.h

@@ -24,6 +24,12 @@
     along with this program.  If not, see <http://www.gnu.org/licenses/>.
 */
 
+/*----------------------------USER PARAMETERS-----------------------------*/
+/*-------------DEFINE YOUR MQTT PARAMETERS BELOW----------------*/
+#define HUM1   "home/DHTtoMQTT/dht1/hum"
+#define TEMP1  "home/DHTtoMQTT/dht1/temp"
+#define dht_always true // if false when the current value for temp or hum is the same as previous one don't send it by MQTT
+#define TimeBetweenReadingDHT 30000 // time between 2 DHT readings
 /*-------------------PIN DEFINITIONS----------------------*/
 #ifdef I2C_Wiring // With Support for I2C Modules
   #define DHT_RECEIVER_PIN 14 //on nodeMCU this is D5 GPIO14